3 Best
Downdraft Electric Ranges
-
Product Highlights- Galvanized iron material: the 4 inch vent ducting damper is made of quality galvanized iron with high hardness and high temperature resistance, not easy to deformation and corrosion, and can effectively prevent the air duct damper from moisture and fading, which can be applied for a long time
- Easy to install: you simply slide the air ducting damper into the pipe and screw it in an easy to adjust position, then hide the seam with tape to complete the installation; it is also recommended that you can seal all connections with pipe sealant to prevent air leakage and improve the efficiency of the hvac system
- Suitable size: the bend end interface of air duct damper measures about 3.87 inches/ 9.84 cm in diameter while the other side is about 4 inches/ 10.16 cm in diameter and the height is about 6 inches/ 15.24 cm in height, which is suitable for inserting 4 inch ventilation duct
- Use for air balance: the hvac damper is a simple manual damper wrapped in galvanized iron sheet metal sleeves; each branch should be fitted with an air duct damper to regulate the airflow by adjusting the position of the damper, which can help to redirect it to specific locations in the house; the 4 inch backdraft damper is not completely sealed, and it is applied for a...
- Fit most occasions: the 4 inch hvac damper can be applied on most occasions including air conditioning, dryer vents, exhausts, range hoods, heating systems, fans, vents and other residential, commercial and industrial hvac applications, practical tools to use
SHOWview product -
Product Highlights
- High quality materials: 4 inch inline fan vent deflector is made of quality galvanized steel, and the axis and spring are made of stainless steel, product very solid and well made, good tension on the spring.
- Practical design: backdraft damper has a smooth-running spring. the backflow flap opens and closes automatically at low air volumes. backdraft damper can ventilate an area to avoid toxic fumes from building up.
- Product size: the 4 inch backdraft damper diameter 100mm/4 inch, length 88mm/3.5 inch, thickness 0.5mm/0.02 inch. please confirm the size before purchase.
- Easy to installation: the backflow flap is installed by inserting it into the ventilation pipe until it stops. the position of the spring should be horizontal for horizontal installations so that it can open and close optimally. the backdraft shutter is installed so that the damper blades open only in the outflowing air direction.
- Wide range of usages: these one-way airflow ducting insert can be widely applied in exhaust fan pipe, a dryer duct, range hoods, heating ducts, vents and other residential and industrial applications.
SHOWview product -
Product Highlights
- Gives you the advantage of having a premium downdraft table in your shop at a fraction of the cost
- Hole size and hole grid pattern design fully optimize dust-collection suction; ensures cleaner breathing air and neater shop-room surfaces
- Kit includes (4) 6-11/16" x 16-1/2" solid-steel downdraft panels - flange measures 13/16"; durable and long lasting; box not included
- Comes with non-marring, nonslip rubber grommets and movable plastic stops for workpiece support, protection and stability
- Other dimensions: panels: 16-1/2" in length x 6-11/16" in width x 13/16" in thickness /grommet holes: 1-1/8" dia, 16 per panel / stop holes: 25/32", 16 per panel/ stop size (above the panel): 15/16"dia x 13/32", 2 per panel - plastic held in place with plastic nut/ grommet size (above the table) 1-5/16"dia x 3/16", 16 per panel - rubber held in place by formed groove
SHOWview product
Coupon copied
