5 Best

Rated Digital Thermostats

of May 2024

  1. Product Highlights
    • Energy cost savings: thanks to the precision room temperature sensor thermostat for automatic switch on and off to maintain your set temperature. also fitted with a advanced quick heat up and slow cool down aluminium heating element, you can be sure this heater is saving you money on your heating bills.
    • Safe for bathrooms: ip24 rated and advanced overheat protection means this heater is perfectly safe for use outside zone 2 in bathrooms thanks to their splash proof design and construction. please note if the heater is to be installed in a bathroom it must be installed by a qualified electrician.
    • Simple installation: installation of our mylek 1500w electric panel heater couldn't be easier, with it specially designed wall bracket, which can be used as a simple wall template for quick fitting, you will have your new digital panel heater fitted and heating your home in no time. or simply use floor standing with its easy to install feet with casters for extra mobility.
    • 24/7 timer & 3 program lcd display: fully program the heater to your desired settings and temperature for every hour of every day of the week, choosing between three heat modes either comfort mode, eco mode or frost protection mode.
    • Lot 20 erp compliant: complies with the new directive for electric panel heaters. “eco” lot 20 of erp directive, which means that mylek offer you the safest most up to date energy efficent heaters on the market. dimensions: wall mounted length 738 x width 115 x height 445 mm.
  2. Product Highlights
    • Two defrost modes are available through the “tdf” parameter: defrost through electrical heater (tdf= el) and hot gas defrost (tdf = in). other parameters are used to control the interval between defrost cycles (idf), its maximum length (mdf) and two defrost modes: timed or controlled by the evaporator’s probe (p2p).at the end of defrost dripping time is started, its len...
    • Cyclical activation of the fans with compressor off. when fnc = c-n or c-y (fans in parallel to the compressor), by means of the fon and fof parameters the fans can carry out on and off cycles even if the compressor is switched off. when the compressor is stopped the fans go on working for the fon time. with fon =0 the fans remain always off, when the compressor is off.
    • The regulation is performed according to the temperature measured by the thermostat probe with a positive differential from the set point: if the temperature increases and reaches set point plus differential the compressor is started and then turned off when the temperature reaches the set point value again. in case of fault in the thermostat probe the start and stop of...
    • Forced activation of fans this function managed by the fct parameter is designed to avoid short cycles of fans, that could happen when the controller is switched on or after a defrost, when the room air warms the evaporator. functioning: if the difference of temperature between the evaporator and the room probes is more than the value of the fct parameter, the fans are ...
    • Check the supply voltage is correct before connecting the instrument. do not expose to water or moisture: use the controller only within the operating limits avoiding sudden temperature changes with high atmospheric humidity to prevent formation of condensation. warning: disconnect all electrical connections before any kind of maintenance. fit the probe where it is not ...
Coupon copied
Opening Product name Amazon page In 05 seconds Cancel
Get exclusive articles, recommendations, shopping tips, and sales alerts
Sign up for our newsletter to receive weekly recommendations about seasonal and trendy products
Coupon copied to clipboard
We use cookies to enhance the security, performance, functionality and for analytical and promotional activities. We use cookies to personalize ads for you. By continuing to browse this site you're agreeing to our Privacy Policy. Got It
You're currently offline